If the cellar is too raw, condensate on the ceiling or moldy walls - you need to neutralize as quickly as possible and destroy all this negative. Otherwise, the greatest doubt will be preserved in the proper condition and form of reserves for the winter season. How to remove dampness in the basement? This is enough important question right now it is worth finding an adequate answer.

Dry cellar - a great place to store vegetables, fruits and other stocks for the winter

If condensate in the basement, damp and wet - it is necessary to put an end to this, and as early as possible. In order to ensure the maximum preservation of fresh products and preservations, it is important to maintain temperature indicators at the optimal level: + 2-4 degrees. This temperature should remain in this place all year. In the summer season, the temperature indicators in the normal cellar should not be more than + 5-7 degrees. In order to provide such a temperature, you need to create appropriate conditions, to do everything possible in a timely manner in order to properly equip such an important place as a cellar.

Get rid of dampness

• To begin with, it is necessary to identify the cause, because of which we have a raw basement.

When increasing moisture in the cellar in the spring-summer season due to atmospheric precipitation, it is necessary to cover the surface of the floor with a layer of gravel.

You can also use sand instead - the thickness indicator is ten centimeters. The walls are cleaned of mold lesions. The same applies to the fungus - it needs to be eradicated. For this, the surface of the walls is covered with plaster - special, waterproofing. It is appropriate to dilute - for this it will take dry ordinary plaster.

• With the increase in the level of water that are soil, the deprived cellar will help ensure the provision of good floorproofing of the floor. To do this, cover the basement floor with several bitumen layers. Further, it is heated by a construction hairdryer, a pair of rubberoid layers are stacked - their thickness should be from 15 centimeters.

Get rid of moisture - the cellar must be dry

Conceonated walls are more resistant to dampness

In order to get rid of moisture, the concreting of the floor and walls will help excellently. In addition, you can successfully take the glass helpers - only liquid. And also only. If clay prevails on the floor in the house, it is necessary to remove the top layer - the thickness should be five centimeters here. Then the film from polyethylene is placed - it must be collapsed in half. After that, the clay on top is rambling, concrete is poured on top. Often over the clay layer, the sand layer is poured. After that pour concrete. If the reason why humidity in the cellar is observed is bad ventilation, then it is necessary to install exhaust holes with fans to get rid.

Folk ways - victory over moisture

1. On the floor, as well as the shelves, containers with a white moss powder.
2. It will help the usual salt - it should be poured with sulfuric acid.
3. It is great for drying the wall harated lime - it should be pouring into a barrel of plastic and leave in the corner in the cellar.

Let's say "no" condensate in the cellar

Condensate in the cellar is a natural consequence of dampness and high moisture. Sleep the cellar can against the background of a variety of factors:

1. Waterproofing in quality leaves much to be desired.
2. The cellar stores too many vegetables and fruits.
3. No normal ventilation.

Wine cellar - Dream of every country house owner

In order to prevent condensate in the cellar in the cellar, it is important to destroy the products unsuitable for food. In addition, a great solution is to whitewash the surface, dry it at the maximum. As a result, it is possible to avoid condensate on the walls and on the ceiling.

In the summer they are processed using hot water. Soap is added, elements made of wood, which are in the cellar are dried. Antiseptic impregnation is also relevant to deal with condensate and as the prevention of its appearance - impregnation is applied to a tree. Thus, it is possible to protect against fungus.

In order to get rid of condensate formation on the ceiling, an excellent solution is insulation. To do this, it is best to use foam.

In the event of an education in the condensate cellar, drying is necessary - for this you use the iron stove. Also for drying can be used brazier.

Before that, the premises in a natural way - it will take several days.

Effective drying, for which ordinary candles use. They are put under the exhaust pipe. As a result, the natural thrust of air is improved. A long dry dryer is about four days. This is a very simple, but quite effective method. You can still spend drying, using special dryers.

What if in the house is a raw basement

How to get rid of damp in the cellar? This question worries many people, because this is a fairly unpleasant phenomenon that can appear even where it would seem that all the conditions are created to avoid this.

Dampness in the basement

Dampness is quite dangerous. Because of her in the basement, fungi and mold appear. In addition, the temperature and moisture mode is disturbed.
Condensate leads to the emergence of microorganisms that are dangerous to health, they cause serious ailments.
As a result of dampness, the walls, overlappings are wedged, finishes. It is very important to get rid of dampness in the basement.

How to deal with dampness in the basement

The basement also requires proper care, otherwise its gender and walls will cover fungus and mold

To begin with, it is necessary to determine the reason for the wetting of the surface. Further, all actions will be directed to getting rid of excessive moisture, depending on the source. The reason can be determined by where the moisture is located. So, if the droplets appeared on the ceiling or walls, then there is insufficient ventilation. If the drops of fluid were formed solely on the walls, this suggests that there are no vertical waterproofing of the walls in the cellar. If there are puddles on the floor - this indicates the flooding of groundwater.

Solve the problem with insufficient air exchange is quite appropriate by creating additional ventilation. This applies to dampness in the attic or in the basement.

Basement - how to remove moisture?

In order for the soil to the basement, humidity does not penetrate, it should still do everything possible during construction to prevent this. To do this, it is appropriate to create an edge drainage sewer - it is carried out around the perimeter of the house. In addition, thorough waterproofing of the foundation will also become a relevant event in this case. The list should add waterproofing of the floor in the subfield and the device of the unit around the base in the house. In addition, it is necessary to remove drainage for rainwater into drainage sewers.

When the necessary works have already been completed, you need to fill in the trench of the rammed clay - this is done around the perimeter of the house. Thus, it is possible to create a water shutter around the foundation. Clay almost misses water. As a result, the trench will work as additional isolation.

Why in the cellar condensate

Venting a natural way - the correct way to protect the cellar from the appearance of condensate

Contacting warm air and cold surfaces is the main one, you can even say the only reason condensate formed. When the air exchange is sufficient, then the air, heating from the interior, is cooled. In this case, condensate is not formed. To perform ventilation in the basement or in the attic, a pair of efficient methods are used - ventilating naturally, as well as forcibly. In the first case, the ventilation includes products, as well as ventilation channels. What to do if dampness, moisture drops on the ceiling or walls appeared in the basement or in the attic? Installing ventilation boxes or pipes are needed. Since after the end of the construction of the house it is no longer possible to position the ventilation channels in the walls, they must be attached to vertical structures.

Basement - Condensate Causes

Dampness in the basement, the deprived cellar is harm to health. If you keep products for the purpose of storage in such a place, they will quickly ruin. The reasons for which the condensate is possible and most likely will happen in the condensate cellar, akin to those faced by the owners of apartments in which plastic windows are installed. When in the house is warm, and outside the frost, the room is not ventilated - droplets of moisture appear on the windows. On the ceiling, the occurrence of condensate is possible for two main reasons: ventilation and temperature difference. Eliminate these reasons - and everything will be fine. Therefore, it is important not only to insulate the room, but the presence of ventilation is necessary.

Condensate in the cellar - how to get rid of

Competently equipped the cellar, you can enjoy the taste of stored fruit almost until the spring!

In this case, ventilation will come to the rescue - natural or forced. The same applies to the insulation of the ceiling. In order to insulate the ceiling, the foam is used. Over the cellar most often the floor of the concrete. He quickly freezes. Therefore, to exclude in this case the temperature differences becomes possible by the ceiling insulation. Almost everyone can cope with such a task. There is nothing complicated here. Extracted polystyrene foam or foam, which is more dense. With their help, you can simply be perfectly insulated the room.

Mold in the cellar - how to get rid of

If negative changes have occurred in the cellar - the mold is observed, you need to do everything possible to clean it as quickly as possible.

In order to defeat the mold, get rid of her presence, you need to go through several stages. At first, at the preparatory stage, all the tools should be taken out of the basement. The same applies to boxes. The list should also add racks. Everything is carried out, carefully dry. Next is cleaned - all the garbage that managed to accumulate during this time should be destroyed. With the help of scraper brushes from the walls removed mold. It is also appropriate to fry a cellar with a smoke checker. The ventilation holes should be closed, after which it is carefully covered with a hatch or door. Wall disinfection is carried out.

Create in the cellar proper, suitable microclimate is a fairly difficult task. It all depends on what indicators from the environment. It must be remembered when only the bookmark of the premises under construction begins. Tight soil, like clay, perfectly carries out heat. This leads to the fact that the air in the cellar in the clay cellar is heated in the summer and freezes in the winter season. In order for this, it does not happen, it is necessary to apply effective materials with thermal insulation properties to properly equip the cellar.

In order to maintain the optimal temperature in the sandy or sub-soil cellar, you do not need to do anything. After all, the optimal temperature is perfectly preserved here all year round. The thing is that the soil is distinguished by bad thermal conductivity.

For those who have a problem with the basement, there is a condensate, damp in the cellar, you need to do everything possible to solve the problem as quickly as possible. After all, otherwise all products will be ruined. So, it is necessary to adhere to useful recommendations that were given above.